ポータブル・マイクロ分析装置のための空気圧駆動マイクロ分注チップ(第1報,空気圧を利用した分注原理の実証)
ポータブル・マイクロ分析装置のための空気圧駆動マイクロ分注チップ(第1報,空気圧を利用した分注原理の実証)
カテゴリ: 論文誌(論文単位)
グループ名: 【E】センサ・マイクロマシン部門
発行日: 2012/07/01
タイトル(英語): Pneumatic Micro Dispenser Chip for Portable Micro Analysis Devices(1st Report, Verification of Dispensing Principle using Air Pressure Drive)
著者名: 長谷川 忠大(芝浦工業大学 工学部 電気工学科),辻 亨之(大阪工業大学 大学院 工学研究科),生田 幸士(東京大学 大学院 情報理工学系研究科)
著者名(英語): Tadahiro Hasegawa (Shibaura Institute of Technology), Toshiyuki Tsuji (Osaka Institute of Technology), Koji Ikuta (Tokyo University)
キーワード: マイクロ分注チップ,チェックバルブ,マイクロ流体検知,化学IC,μ-TAS Micro dispenser chip,Check valve,Micro liquid detection,Biochemical IC,μ-TAS
要約(英語): The prototype of the pneumatic micro dispenser chip for portable micro analysis devices was developed successfully. This micro dispenser succeeded to divide liquid into 1μL without any dead volume by decompressing and the compressing air in only one micro pump. The dispensing operation is achieved by the original micro liquid detecting method and four hat-shaped check valves. The detecting method utilized the refraction of the infrared rays LED. Not only passage of the fluid into the channel but also its existence can be detected as TTL level signal. The hat-shaped silicone rubber valve which functions itself as a unidirectional passive valve was proposed. The check valve with low opening pressure (3kPa) and high inverse pressure (over 300kPa) was developed successfully. This micro dispenser chip is useful for portable micro analysis devices.
本誌: 電気学会論文誌E(センサ・マイクロマシン部門誌) Vol.132 No.7 (2012)
本誌掲載ページ: 195-202 p
原稿種別: 論文/日本語
電子版へのリンク: https://www.jstage.jst.go.jp/article/ieejsmas/132/7/132_195/_article/-char/ja/
受取状況を読み込めませんでした
